ICT259: Computer Networking Assignment, SUSS, Singapore: Figure Q4 shows the network topology of a company

(b) Assume that all the routers in the network shown in Figure Q4 are enabled with only Routing Information Protocol version 2 (RIPv2) routing protocol. Write down the router configuration commands to be entered on all the routers to achieve reachability in the entire network.

(c) Assume all the routers are configured with RIPv2 routing protocol, and it is desired to have backup static routes for PC1 to reach PC2 and vice versa via Routers A, B and E. Give the configuration command(s) to set up the static routes and indicate the router(s) where the commands are implemented.

(d) Use Packet Tracer to set up the network topology given in Figure Q4. Use router model 1841 for all the routers, and add interface module WIC–2T to slot 0 to all the routers. For Routers A and B, add an additional interface module WIC–1T to slot 1, and for Router D, add an additional interface module WIC–2T to slot 1 Use model 2960 for the switch.

The Ethernet interfaces available on the routers are Fa0/0 and Fa0/1. Use Fa0/0 for Ethernet interface. For serial interfaces, use S0/0/0, S0/0/1, S0/1/0, S0/1/1 if up to 4 serial interfaces are required.

Name the routers (Display Name and Hostname) using the initials of the router name followed by your PI Number. E.g., If your PI number is S1234567, name RouterA as RA–S1234567, RouterB as RB–S1234567, etc. Likewise, name Switch1, PC1 and PC2 as S1– S1234567, PC1– S1234567, and PC2– S1234567, respectively.

Complete the configurations for the 2 PCs.

Save the Packet Tracer (pkz or pkt) file to the Vocareum Lab Workspace using the following file name convention:

(i) Check the routing table by issuing the show ip route command as shown below.
Router> enable