University | National University of Singapore (NUS) |
Subject | TIE2130: Quality Engineering |
TIE2130: Quality Engineering Assignment, NUS, Singapore Perform a GRR study using Method I based on the data shown in Table 3 and Include all the steps covered in Topic 5
Question
(a) Perform a GRR study using Method I based on the data shown in Table 3. Include all the steps covered in Topic 5. The specifications are 60 ± 20 grams. Assume that Pa must be smaller than 0.2 based on the 6-sigma PIT formula. Show that the ball shear tester meets the requirement.
(b) Should there be a switch in the bonding temperature from 280°C to 240°C? Using Approach 2 of process capability analysis, do an SPC study based on the information and data given in Tables 1 and 2. Show your work clearly and give your recommendations, including the justifications and assumptions made, and any possible limitations. The lower specification limit of the ball shear strength is 40 grams (the unit used in Table 1 and 2). The upper specification limit is not applicable and can be ignored. Assume that the required Cs is at least 1.5.
(c) Compare and comment on the process FNC that would be generated at the two different levels of bonding temperature.
(d) At 240°C, what should the LSL be to achieve a Cs of exactly 1.5?
(e) The process engineer pointed out that at 240°C the process means can be increased by 10% from the currently observed level through adjusting another process parameter. Assume that this 10% improvement is achievable and LSL is 40 grams. Compute the maximum process standard deviation that would give a Cpk of at least 1.5.
Buy Custom Answer of This Assessment & Raise Your Grades
Table 1: Data on the ball shear strength (X) collected at a bonding temperature of 280°C.
Table 2: Data on the ball shear strength (X) collected at a bonding temperature of 240°C.
Table 3: Data for a GRR study for the ball shear tester.
Stuck with a lot of homework assignments and feeling stressed ? Take professional academic assistance & Get 100% Plagiarism free papers
Looking for comprehensive academic support in Singapore? Look no further! We specialize in tma, individual assignments, essay writing service, and assignment writing service, offering expert guidance to students. If you're at the National University of Singapore (NUS), our platform is your go-to solution. Master TIE2130: Quality Engineering with our assistance, performing a GRR study using Method I based on provided data. With our support, excelling in assignments like the Quality Engineering Assignment at NUS, Singapore, is within your reach. Invest in your academic success – choose our reliable services today
- Business Accounting & Finance – (VM) – A3 Assignment, UOM, Singapore
- HRM3010S: Managing People At Work, Assignment, UCD, Singapore
- HFS351: Safety Management and Audit, End-of-Course Assessment, SUSS, Singapore
- HFSY217: Emergency Preparedness and Response Planning, TMA (Tutor-Marked Assignment), SUSS
- CMM315: TMA (Tutor-Marked Assignment) – Peacebuilding and Security, SUSS, Singapore
- Harley Davidson utilized different entry mode strategies in pursuit of internationalization: Sustainable, Assignment, UoN, Singapore
- Nursing Patients With Chronic Illness, Assignment 3, LTU, Singapore: Jason Bundhoo is a 42-year-old car driver from Triolet
- DSM: R for Data Science, Coursework 2, UOL, Singapore: In this coursework assignment you should return to this dataset and perform an appropriate investigation into building a statistical model
- DSM120: Financial Data Modelling, Coursework 1, UOL, Singapore
- Data Science Final Project, Coursework 1, UOL, Singapore: Your first formal coursework submission is your full project proposal, This sets out very clearly what your Data Science Project will be, and also how you will conduct the project
UP TO 15 % DISCOUNT